Plumber in Baytown, TX for Rusty Hot Water, Weak Water Pressure and Repiping Older Goose Creek Homes
Primary Plumbing Services: Serving Baytown Homeowners
Updated November 2026
Primary Plumbing Services is a plumber in Baytown, TX, across the Ship Channel from our office near Ellington Field by SH 225 and SH 146. Older Baytown blocks near Goose Creek, Lakewood and North Main still carry galvanized water lines, so rusty water and low pressure are the calls we get most there.
Most single-story repipes run $4,500-$13,000+, and installed tank water heaters run $2,185-$3,500+. Call 713-643-7228, 24/7.
- Test first to tell pipes from the heater.
- PEX repipes for older Baytown homes.
- Water heaters replaced under City permits.
- Baytown permits pulled for repipes and heaters.
- Family owned since 1986, BBB A+ accredited since 2001.
Check My Pipes
Fast callbackHomes: leaks, drains, water heaters, softeners, repipes and sewer lines.
Tell us what's happening and our office will call you back. Emergency? Call 713-643-7228, 24/7.
- Family Owned Since 1986
- Commercial and Residential
- 24/7 Emergency Plumbing
- Clear Estimates Before Work Starts
"Primary Plumbing has knowledgeable, friendly employees who arrive on time and fix issues without trying to upsell. We've had them work on jobs ranging from clearing clogs to repiping an old house. Most recently, the water line feeding our house was ruptured during foundation work. Primary Plumbing responded to my call within minutes and had a technician at our house within an hour, at 5 PM on a Friday. He worked till after 10 PM digging down to find and replace the damaged pipe. It was hot (August in Houston) and dark, but he fixed it. The folks at Primary Plumbing are good people!"
Dustin Crandall , Google review
About Primary Plumbing Services
Ruben Munoz, PresidentPrimary Plumbing Services has been independently owned and operated by the Munoz family since 1986. The leadership team includes Ruben Munoz, President; Ruben Alex Munoz, Vice President of the Service Division; Melissa Gonzalez, Vice President of Business Development; and Andrew Gonzalez, Vice President of the New Construction Division.
Nearby service areas
Primary Plumbing Services Serving Baytown Homeowners
New copper water piping with a brass valve runs along a block wall outside a building.
Is Rusty Hot Water in My Baytown Home the Pipes or the Water Heater?
Comparing Hot and Cold Water to Find the Source
Run cold water, then hot water, at a faucet near the water heater and at one far from it. If only the hot side runs rusty, the heater tank or the hot-side piping is the likely source. If both sides are rusty or weak, the galvanized supply lines are the bigger problem.

| What You See | Most Likely Source | Next Step |
|---|---|---|
| Hot rusty, cold clear, at every faucet | Water heater tank or hot-side pipe near it | Drain test and heater check |
| Hot and cold both rusty | Galvanized supply lines | Check the pipe, price a repipe |
| Low pressure on hot and cold | Rust buildup inside galvanized pipe | Pressure test, repipe quote |
| Rusty at first, then clears | Rust flaking in idle pipe | Watch it, check pipe age |
| One faucet weak, others fine | That faucet's aerator or branch | Clean or repair that fixture |
Can a New Water Heater Fix Rusty Water in an Old House?
Only if the tank is the source. In a house with original galvanized pipe, a new heater can still put out rusty, weak water because the rust is coming from the lines. We check the pipe before you spend money on a heater.
Should I Repipe My Older Baytown House?
How Pipe Material Guides a Repipe Decision
If galvanized pipe runs through the whole house and pressure keeps dropping, a whole-house PEX repipe fixes it for good. If only the hot side is galvanized, a hot-side repipe can be enough. A single bad section gets a repair.

| What We Find | What We Recommend |
|---|---|
| Galvanized throughout, heavily rusted | Whole-house PEX repipe |
| Galvanized on the hot side only | Hot-side repipe |
| Copper or PEX, rusty heater tank | Water heater replacement |
| One corroded section | Spot repair |
| Several leaks and falling pressure | Whole-house repipe |
What Should a Baytown Repipe Estimate Include?
Every estimate we write lists each of these, so you can compare it line by line:
- All hot and cold supply lines , not only part of the house.
- New shutoff valves at every fixture.
- Water heater connections.
- The City permit and inspection.
- Drywall patching , or a clear note that it's not included.
- What happens to the old pipe , removed or left in place.
A whole-house water repipe doesn't replace drain or sewer pipe. If your drains are cast iron, we'll tell you what we see, and Houston's plumbing code doesn't allow trenchless lining for cast iron soil pipe. See PEX repiping.
Does Baytown Require a Plumbing Permit?
Baytown Permit Requirements
Baytown requires a permit for residential plumbing work other than replacing fixtures, so a repipe or a water heater replacement needs one. Permits go through the City's Citizen Self Service portal, and the same portal schedules inspections.

| Baytown Permits | Details |
|---|---|
| Permit needed | Plumbing work other than fixture replacement |
| Repair or replacement of existing | $100 residential MEP permit |
| Alterations and additions | $140 residential MEP permit with plan review |
| How to apply | Citizen Self Service portal |
| Plumbing code | 2015 IPC, per the City's Building Codes page |
| Building Services | 281-420-6537, 2401 Market Street |
Building Services is open Monday to Thursday, 7:30 a.m. to 5:30 p.m., and Friday, 7:30 to 11:30 a.m.
Is My Baytown Address Inside City Limits?
Not every Baytown mailing address is inside the City. Some homes sit in unincorporated Harris County or Chambers County, and those permits go through the county instead. We check your address before we pull the permit.
How Much Does a Plumber Cost in Baytown, TX?
Clear Estimates Before Work Begins
A plumber in Baytown, TX usually costs $130-$250+ for a service call, $2,185-$3,500+ for an installed tank water heater and $4,500-$13,000+ to repipe a typical single-story home. You get a clear estimate before any work starts.

| Baytown Plumbing Job (2026) | Typical Range |
|---|---|
| Service call | $130-$250+ |
| Small single-story repipe, 1 to 2 baths | $3,500-$9,500+ |
| Average single-story repipe, 2 to 3 baths | $4,500-$13,000+ |
| Two-story repipe, 3+ baths | $7,000-$20,000+ |
| Drywall patch and texture | $400-$3,500+ |
| Main water line, meter to house | $800-$4,000+ |
| Tank water heater, installed | $2,185-$3,500+ |
| After-hours emergency | $100-$500+ |
See water heater repair and plumbing repair.
Baytown Neighborhoods We Serve
Established and Newer Baytown Neighborhoods
Baytown mixes mid-century homes near Goose Creek, Lakewood and North Main with newer subdivisions off Garth Road and I-10. The older side brings galvanized pipe and clay sewers. The newer side brings water heater and slab leak calls.

| Area | What We See Most |
|---|---|
| Goose Creek and North Main | Galvanized lines, rusty water, clay sewers |
| Lakewood | Low pressure, seized gate valve shutoffs |
| Bayway Drive and San Jacinto Boulevard | Repipes, sewer backups |
| Garth Road corridor | Water heaters, slab leaks |
| Decker Drive and Massey Tompkins | Water heater swaps, fixture leaks |
Older Goose Creek homes often still have a gate valve main shutoff that seizes when you need it most. Swapping it for a quarter-turn valve is a quick upgrade we make on many Baytown calls.
Frequently Asked Questions About Plumbing in Baytown
Common Questions From Baytown Homeowners
How do I know if my Baytown house has galvanized pipe?
Look at the pipe near the water heater or under a sink. Galvanized is dull gray steel with threaded joints.
How long does a repipe take?
Most single-story homes take 2 to 4 days, with water back on each night.
Where does Baytown's water come from?
The Trinity River, treated by the Baytown Area Water Authority and delivered through the Coastal Water Authority canal.
Do I need a permit to replace a faucet or toilet in Baytown?
No. Replacing a fixture doesn't need a permit, but changing the piping does.
How fast can you get to Baytown?
Our office schedules service as quickly as possible, and the Primary Plumbing Services team travels over the Fred Hartman Bridge or by I-10.
Do you work on Baytown businesses?
Yes. See business plumbing services.
Plumbing Near Baytown
Neighboring Communities We Serve
We cover Baytown from 11700 Playa Ct. See Houston plumbing services or our full list of service areas.

- Plumber in Channelview, TX
- La Porte plumbing service
- Deer Park plumbing service
- Plumber in Pasadena, TX
Reviewed by Ruben Munoz, President, Primary Plumbing Services
Call Primary Plumbing Services, Your Plumber in Baytown, TX
Schedule Plumbing Service in Baytown
Pipes or heater, found first. Call 713-643-7228.
Contact Us
We will get back to you as soon as possible.
Please try again later.
